Re: [dvd::rip] dvd::rip detects wrong resolution

[Suman Chakrabarty <suman@xxxxxxxxxxxxxxxxxx>]

Adam Felson wrote:
> On Thursday 01 January 2009 6:55:28 am Suman Chakrabarty wrote:
>> I am trying to rip a DVD with following details detected with mediainfo:
>>
>> Width                            : 704 pixels
>> Height                           : 480 pixels
>> Display aspect ratio             : 4/3
>>
>> But when I read the DVD TOC in dvd::rip, it reports the resolution as
>> 352x480 (Aspect 4:3), which is certainly wrong!
>>
>> The Clip & Zoom tab shows the following:
>>
>> After 1st Clipping: 352x480
>> Eff. ratio: 0.73
>> Phys. ratio: 0.73
> 
> Make sure the frame where the automatic clipping was performed wasn't one 
> with 
> a lot of dark regions.  Sometimes the autoclip gets confused.  Select a 
> different frame, then 'grab frame' and 'apply preset values'.  Also click the 
> third frame and manually move the borders if necessary.
> 
> In your case, you have full vertical resolution (480).  The 352 is what you 
> got when most of the sides were clipped away.



I'll try to check with different frame next time. But it should report
the original resolution while reading the TOC (even before ripping).
Does it autoclip even before that and reports the clipped resolution?!
It should not be the right way to go!




-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.